Knowledge base 194: Error when encoding dual technology cards in MorphoManager
Scenario:
Using Mifare Classic & EMProx combination cards with an Omnikey 5427CK to encode cards with MorphoManager.
Using Mifare Classic & EMProx combination cards with an Omnikey 5427CK to encode cards with MorphoManager.
Problem: When encoding the cards you can occasionally see this error when writing or erasing the card -
Solution:
Log into the Omnikey 5427 webpage via this URL (http://192.168.63.99)
Firstly ensure under the Keyboard Wedge settings that you have disabled all Prox technologies from the dropdown menu -
Secondly, go into the Contactless Config and then Polling Config. Untick Prox from the centre list as highlighted below -
Secondly, go into the Contactless Config and then Polling Config. Untick Prox from the centre list as highlighted below -
This should resolve the errors, but should you continue to experience issues, please email support@controlsoft.com
Related Articles
Knowledge base 191: Encoding cards in MorphoManager with the Omnikey 5427 CK
This article explains how to set up MorphoManager to encode cards using the HID Omnikey 5427 CK G2 reader. Requirements: Hardware - HID Omnikey 5427 CK G2 Drivers - Omnikey EEM Driver - https://www.hidglobal.com/drivers/34881 Omnikey CCID Driver ...Knowledge base 168: Encoding multi technology cards in one pass using Asure ID Exchange Edition
Multi-technology cards can be encoded in just one single process. In order to do that just add a Work instruction to the base Work Order. There are some unsupported multi Technology cards found in the Release Notes of the CP1000D. Here is an example: ...Knowledge base 108: Identity Access 8 - Sigma Series HID Prox 26 bit Settings
This requires an IA-PRO license if you do not have an IA-PRO license please contact sales@controlsoft.com The following Knowledge base describes the 3 options of how to configure Identity Access to work with the Idemia Morpho Series HID Prox ...Knowledge base 150: Using MorphoManager for Contactless (MorphoWave Compact) fingerprint encoding to smart cards.
This bulletin explains how to use the Morpho Wave series reader for 2 factor (card + bio) or 3 factor (card + bio+ pin). Equipment required - MorphoManager 14.6.0 (or newer) MorphoWave Compact reader (Firmware 1.2.2 or newer) Morpho MSO 300/1300 ...Knowledge base 119 - Why is my dual technology card not working on my multiCLASS reader?
Problem: Why is my dual technology card not working on my multiCLASS reader? I am getting misreads and other errors. Solution: Combination cards have two or more technologies within the card. Typically the cards have 125 kHz technology and 13.56 ...