Artillery 3D Technology Co., Ltd.

Changing materials

Materials can be changed easily on the Genius by using the procedure from the menu. Besides changing a material you also have the option to load or unload material.
  1. Go to the menu TOOLS CHANGE.
  2. To unload the material currently in the machine, press OUT.
  3. Wait for the nozzle to heat up and press on Confirm.
  4. Wait for the reverse of the material to finish, remove it from the extruder.
  5. To load a new material, repeat Step 1 to 4, except pressing IN in Step 2 instead.


    • Related Articles

    • Changing materials

      Materials can be changed easily on the Sidewinder X1 by using the procedure from the menu. Besides changing a material you also have the option to load or unload material. Go to the menu TOOLS > CHANGE. To unload the material currently in the ...
    • Materials

      General material information What materials can be used with the Sidewinder X1 (SW-X1)? The SW-X1 supports the use of PLA, ABS, PETG, TPU, TPE, and some high temperature filaments may need to change to all metal throat. What diameter filament should ...
    • Hardware

      General information At what resolution does the Genius print? The Genius supports layer heights between 80 microns and 320 microns (with stock 0.4mm nozzle). What are the recommended operating conditions for the Genius? Artillery recommends an ...
    • Build plate leveling

      While using your Genius it is necessary to periodically calibrate the build plate for good adhesion of the print to the build plate. If the distance between the nozzle and build plate is too wide, your print won't adhere properly to the glass plate. ...
    • ARTILLERY LIMITED WARRANTY

      LAST DATE UPDATED: December 1, 2020 THIS LIMITED WARRANTY (“Limited Warranty”) applies to new and refurbished Artillery hardware devices (Artillery Sidewinder X1, Artillery Genius, Artillery Hornet) (collectively the “Products”) sold by ARTILLERY or ...