How to flash original firmware for X2,Genius Pro,Hornet

• Related Articles

• Build plate leveling

  While using your Genius it is necessary to periodically calibrate the build plate for good adhesion of the print to the build plate. If the distance between the nozzle and build plate is too wide, your print won't adhere properly to the glass plate. ...

• Changing materials

  Materials can be changed easily on the Genius by using the procedure from the menu. Besides changing a material you also have the option to load or unload material. Go to the menu TOOLS > CHANGE. To unload the material currently in the machine, ...

• Hardware

  General information At what resolution does the Genius print? The Genius supports layer heights between 80 microns and 320 microns (with stock 0.4mm nozzle). What are the recommended operating conditions for the Genius? Artillery recommends an ...

• My X axis is not moving

  When your X axis is not moving, it's usually because the Flexible Flat Cable (FFC or ribbon cable) are not inserted correctly, especially for the 30-pin one connecting the breakout board to the base. When checking for problem, don't just pull it out ...

• ARTILLERY LIMITED WARRANTY

  LAST DATE UPDATED: March 2, 2023 THIS LIMITED WARRANTY (“Limited Warranty”) applies to all new and refurbished Artillery hardware devices, including the Artillery Sidewinder X1, Artillery Sidewinder X2, Artillery Genius, Artillery Genius Pro, ...