Printing with USB
When doing a print through connecting to a computer can be interrupted by computer failure or sleep mode, we strongly suggest to print via a USB stick.
- Plug a USB stick to your computer.
- Slice your 3D model in Repetier-Host, Cura, or other slicers of your choice.
- Save the print file (.gco / .gcode) to the USB stick.
- Eject the USB stick and remove it from your computer.
- Plug the USB stick in the Sidewinder X1.
- Navigate to Print and select the file you want to print.
Related Articles
Build plate leveling
While using your Sidewinder X1 (SW-X1) it is necessary to periodically calibrate the build plate for good adhesion of the print to the build plate. If the distance between the nozzle and build plate is too wide, your print won't adhere properly to ...
Build plate leveling
While using your Genius it is necessary to periodically calibrate the build plate for good adhesion of the print to the build plate. If the distance between the nozzle and build plate is too wide, your print won't adhere properly to the glass plate. ...
Hardware
General information At what resolution does the Genius print? The Genius supports layer heights between 80 microns and 320 microns (with stock 0.4mm nozzle). What are the recommended operating conditions for the Genius? Artillery recommends an ...
Hardware
General information At what resolution does the Sidewinder X1 (SW-X1) print? The SW-X1 supports layer heights between 80 microns and 320 microns (with stock 0.4mm nozzle). What are the recommended operating conditions for the SW-X1? Artillery ...