FactoryWiz
            Knowledge Base Browsable FAQ CNC Configuration Sheets CNC Configurations Sheets

            Haas Configuration Document



              DC Systems |
            Haas Confguration Settings


            CNC Configuration Sheet

            CNC Parameters:

            Newer Haas:

            Press SETNG to bring up the machine settings. Press right arrow until you get to I/O tab. Press WRITE/ENTER button (lower right corner of panel). Use left and right arrow to toggle between choices for each setting. Press WRITE/ENTER button to save each new setting. 

            Older Haas:

            Press SETNG to bring up the machine settings. 
            Press Page Down until you see the screen labeled RS-232 PORTS (the label will be in the upper left portion of the screen as you page down).

            Use left and right arrow to toggle between choices for each setting. Press WRITE/ENTER button to save each new setting. 

            Set BAUD RATE SELECT: 9600 
            Set PARITY SELECT: EVEN 
            Set STOP BIT: 1 
            Set SYNCHRONIZATION: DC CODES 
            Set RS-232 DATA BITS: 7 
            Set LEADER TO PUNCH: NONE 
            Set EOB PATTERN: CR LF 
            Set ADD SPACES TO RS232 OUT: OFF 


            FactoryWiz DNC Settings:


            Basic Communication

            1.01- Port Type: Standard

            1.11- Baud: 9600

            1.12- Data Bits: 7

            1.13- ASCII Even

            1.14- Stop Bits: 1

            1.15- Handshake: XON/XOFF


            Sending Options

            2.11- Leader: %<10>

            2.12- Trailer: %

            2.23- Skip lines that contain: %

            2.31- Automatic timeout: 7


            Receiving Options

            3.11- Program identifier 1: O

            3.12- Program Identifier 2:

            3.21- Receive timeout: 3

            3.31- Ignore data before first end-of-block: True

            3.32- Ignore data after last end-of-block: True


            Remote Commands

            4.02- Request for file command: GET-

            4.03- Request for file command (drip feed): DNC-

            4:11- Request to save command: PUT-



            Additional Notes:


            Outputting CNC Programs:

            LIST PROG brings up the program list. 
            To send a program, use the arrow keys to highlight the program you wish to transmit, then press SELECT PROG, followed by SEND RS232. 


            Inputting CNC Programs:


            LIST PROG brings up the program list.

            To receive a program, Press, END.  This will highlight ALL (at the very bottom) and press RECV RS232.

            (On Newer model Haas you will see a Memory Tab. Press WRITE/ENTER to see the Program List and ALL. 




            Wiring Diagram:

            Pinout includes RTS/CTS Handshaking


            DB-9 com port

            Wire color

            DB-25 CNC

            Jumper?


            (Disconnected)

            Shield

            1



            2 (Receive Data)

            Green

            2 (Transmit Data)



            3 (Transmit Data)

            Red

            3 (Receive Data)



            5 (Signal Ground)

            Black

            7 (Signal Ground)



            7 (RTS)

            Brown

            5 (CTS)



            8 (CTS)

            Blue

            4 (RTS)





            6 (DSR)

            8 (DCD)

            20 (DTR)

            JUMPER







            Updated: 03 Jul 2018 04:11 AM
            Helpful?  
            Help us to make this article better
            0 0