Infotainment.com

Security Module Locations for Bypass Module (2018+) (OBDGenie)

2018+ Fiat-Chrysler vehicles require additional steps to program.

You will need to remove the plugs from the gateway module, replace the plugs into the module sent, program the vehicle using the OBDGenie and then remove the module and restore the gateway module to original configuration after programming is completed.


    • Related Articles

    • How to install 2019+ FCA Security Gateway Module Bypass in Heavy Duty Rams

      The bypass must be installed behind the cluster. Below is a video that shows how to uninstall your cluster, install the bypass and program your Genie: https://www.youtube.com/watch?time_continue=2279&v=MhAqc-7AD2k&feature=emb_logo
    • 2018 + Vehicles with a Security Gateway

      The below pictures are from a 2018 Ram 1500, but the Security Gateway module will look the same on all vehicles just different locations 2018 and newer FCA Vehicles come with an OBDII "firewall" (SGW) that blocks any aftermarket connections to the ...
    • Ford Taurus Sync module location

      The Sync module is located under the center console.
    • Cargo Camera Icon

      "My cargo camera icon is not showing up, but I got a green light when I used the OBDGenie?" Perform a can-bus reset. CAN-bus Reset: Remove positive and negative cables from the vehicle battery. Touch and hold the cables together for  5 - 10 seconds. ...
    • [How-To] OBD Genie General Use

      1. Make sure to put in Security Gateway Bypass Module 2. Turn on the ignition for 45 seconds. 3. Put in GENIE