Dealer Mode

Dealer Mode

Method 1:
Hold down the bottom corners of the touch screen for another way to enter dealer mode. 

Method 2:
STEP 1:

• Put the system into ‘Dealer Mode’

• Hold the Driver Side Temp Up and Temp Down and Front Defrost buttons down at the same time for 7-10 seconds (location of buttons may vary across vehicles). The ‘Dealer Mode’ screen should appear

• Touch ‘ System Information’

• Touch ‘ Radio Part Information’
(location of buttons may vary across vehicles)

      

STEP 2:

• In the 'Radio Part Information' Screen, you will see a line called 'Application Version.'

• Take a picture of this information or write it down exactly as it appears per the example below and click ‘CONTINUE’

• Use the back arrow or ‘X’ at top right of screen to exit Dealer Mode.

       Example Only. Each system will have a unique Application Version

As an Example Only:

• The example at left uses Application Version:
USA-ASO-8.4-QR-34.5.2-20200113-Q0C4

(Note: you will need to enter periods and dashes. If you see
‘ASO’ or ‘SBX’ - those are letters. Other <0’s> are likely numbers)

For UAX Dealer Mode Access:

Hold your fingers right under the the icons to the farthest left and right bottom corners of the radio screen.

    • Related Articles

    • UAS / UAQ Dealer Mode

      On HVAC panel press and hold left temperature up/down and front defrost button, or the only temperature up/down buttons you have if you have single zone climate. This is for obtaining serial number and firmware version, if necessary.
    • Ford Explorer Steering wheel Mode Button not working after 4" to 4" Sync 3 Upgrade

      After installing the 8.4" Sync 3 upgrade radio, you may notice that your Mode button on your steering wheel no longer functions, this is due to the radio screen size being tied to the steering wheel configuration. There's a 4-inch Configuration: And ...
    • How to Retain Sport Mode

            To retain Sport Mode when installing an 8.4" radio, enable Sport Mode on your old radio with your engine running. You should see the icon on your vehicle's cluster. With your engine still running and Sport Mode enabled, uninstall your original ...
    • Ford Cluster issues and Troubleshooting

      Ford clusters are programmed by the VIN so, if; Navigation doesn't show up in a cluster: the vehicle may not have had a factory radio with native Nav. The cluster isn't provisioned for the vehicle's steering wheel: check to see if the customer's ...
    • Day/Night Mode Issues When Viewing Maps

      If you're having issues with your navigation unit showing just 'Day mode' or just 'Night mode' please follow these steps:  1. Try to adjust your dimmer in your vehicles dash. This is connected to your navigation unit and may cause the unit to assume ...