FCA - Restoring Vehicle Configuration

FCA - Restoring Vehicle Configuration

How to restore vehicle configuration (Step by Step) 

1. From the Vehicle Select Screen, navigate to the Vehicle Topology Screen or Electronic Control Unit (ECU) List 

2. Select Body Control Modules (BCM) 

3. From the BCM Screen, select the MISC FUNCTIONS Tab 

4. Select the option RESTORE VEHICLE CONFIGURATION 

5. Follow system prompts to complete the procedure 

6. Upon completion, cycle the ignition to OFF, then cycle the ignition to RUN (Do Not crank the engine) 

7. Leave the ignition in the RUN position for a minimum of 60 seconds then cycle to OFF. 

8. Cycle the ignition to RUN (Do Not crank the engine)

9. Clear all Diagnostic Trouble Codes (D.T.C.’s)


    • Related Articles

    • DIFFERENT VEHICLE LOGO AND MISSING ICONS

      If you just installed your infotainment system and is getting a different splash logo. For example; your vehicle is a Jeep Wrangler but the radio shows Ram, that is completely normal and for all FCA vehicles. The radio will eventually adjust itself, ...
    • OBD Genie not programming an older vehicle

      After turning on your Chrysler-based vehicle, letting it sit for 1 minute, then installing your OBD Genie into the OBD II port of your vehicle, if you don't get a solid green light indicating programming, have done a CANBUS reset, and still don't get ...
    • Colored FAKRAs/Connectors behind all Chrysler/Dodge/Jeep radios and modules

      - White; is AM/FM. - Blue; is GPS/Compass. (Only on units not compatible with   - Yellow/Curry; is SiriusXM. (You might find a yellow connector if you remove the blue pigtail on the new unit. Depending on the vehicle, you may find only a yellow port ...
    • AC Climate control visual bug on Ram 1500

      Parts Required Two Genies labeled LD, and DS Wire connector that you will use to connect the sensor Temperature Sensor Security bypass if you are an 18+ year Installation Attach the sensor wire to the open molenex connector on the harness that is ...
    • RA4/RA3 troubleshooting steps

      RA4/RA3 Radio unit won't power on? After installing your 8.4 RA4 or RA3 head unit, and turning on your vehicle, you should get a splash screen right away. If your screen is completely black, with no backlight, with the engine on, put your ear near ...