GM Wireless Charger NOT WORKING
If your genuine GM wireless mobile phone charger it's not working please follow the steps below:
1. Ensure the phone is properly placed. The bottom of the phone should be on the pad. It is perfectly normal for the process to take up to 10 seconds for charging to begin.
2. Flip the phone 180 degrees to see if charging begins (top of phone facing dash vs top of phone facing rear seat).
3. Ensure the case on your phone isn't prohibiting the charging capability. Remove the case temporarily to see if charging begins after 10 seconds.
4. Ensure the smartphone you're using is compatible with wireless charging capability. If unsure, see our advertisement for compatible phones or borrow a phone from a friend that for sure is compatible.
5. Ensure the charger was installed correctly (flush with the bottom side of the armrest lid) and that the adapter cable is securely plugged in.
Related Articles
RAM Wireless Charger - Power Inverter Outlets Not Working
RAM Wireless Phone Charger Listing https://infotainment.com/shop/interior-accessories/wireless-smartphone-chargers/c-bdlwrlchg-dt/ When installing the wireless charger kit, the included harness requires you to pin to connector C5/E on the BCM. The ...
Q: I installed the C-ACC-LD OBD Genie programmer in my 2011-2014 Chrysler 300 / Dodge Charger to enable AUTO temperature control and it's not working.
Q: I installed the C-ACC-LD OBD Genie programmer in my 2011-2014 Chrysler 300 / Dodge Charger to enable AUTO temperature control and it's not working. A: If the programmer's embedded LED turned green then the vehicle's computer has been programmed. ...
Mylink not working
After the customer installs the new module they need to call XM to update their subscriptions and request that MyLink be added. After the customer gets a signal refresh sent to their vehicle. They need to wait 30 minutes and then disconnect the ...
15 Charger/Challenger USB hub Install/removal
These are instructions provided by a customer for an easier install/removal of the USB hub than the removing the entire console. USB Hub Removal/Install For a Charger, the swap of the hub is MUCH easier. While the same may apply to the Challenger, I ...
Steering Wheel Controls Not Working
SWC - Steering Wheel Controls Did you install the XP1 harness (if applicable)? Not all vehicles use the XP1 harness If your original steering wheel control had the phone button and you replaced that with the one from the kit, try your original SWC. ...