Hazard light out, when upgrading from UAV to UAX

Hazard light out, when upgrading from UAV to UAX

upgrading from the UAV to the UAX here is what they will need to do:

1. Disconnect the plug from the rear of the UAV 8.4-inch display and plug it into the UAX 12-inch display.

2. Disconnect the plug from the rear of the climate control portion of the UAV bezel. Remove PIN 8 WH/DB, refer to attached photo "Climate Control Connector"

3. Insert PIN 8 WH/DB (from the climate control connector) into the display connector slot PIN 3 location, refer to attached photo "12-inch Display Connector"


If these steps don't work, a special harness will have to be ordered to correct it.

Also, check to see if any fuses were blown.

    • Related Articles

    • UAX / UAV doesn't give display

      After installing your UAX or UAV upgrade, if you notice that you have a black screen. This is caused by one of two issues: The Genie didn't produce a green LED to properly program the vehicle to turn on the radios screen. To fix this: If you have a ...

    • UAV to UAX Retaining Sirius Guardian / UConnect Access

      When upgrading from a UAV to UAX, you will retain Sirius Guardian / UConnect Access, due to already having the neccassary 4G antenna. You will need to reach out to Sirius Guardian to have the account transferred over to the newly installed UAX, ...

    • UAV & UAX bluetooth range is too short

      After installing a UAV or UAX upgrade, and pairing the head unit with a bluetooth device,  if you notice your linked bluetooth device needs to be extremely close to the unit to hold signal, you'll need a small blue fakra, with an adapter amplifier, ...

    • UAV/UAX windshield wipers won't stop after installing unit/Genie

      Please have your vehicle completely turned off, or battery terminals removed, during the installation process of your retrofit upgrade. If you install this with your vehicle on or in accessory and try to use the Genie, even if it gives you a green ...

    • 2019 Heavy Duty UAV or UAX Upgrade Climate issue

      Since last year we've had an issue where a 2019+ Ram truck customer (who has installed either a UAV or UAX upgrade) increases or decreases their cabin temperature around 70-74 degrees the vehicle either goes full heat or full cold. This happens ...