[How-To] OBD Genie General Use

[How-To] OBD Genie General Use

1. Make sure to put in Security Gateway Bypass Module
2. Turn on the ignition for 45 seconds.
3. Put in GENIE
    • Related Articles

    • Genie Steps

      Never start the vehicle with the OBD Genie plugged in, this can damage the OBD Genie. If you have a 2018+ Year Chrysler, Dodge, Ram or Jeep vehicle, you'll need a bypass module. That bypass module is plugged into the vehicle, before turning on the ...
    • IOB Genie gave green light but screen is black

      This Genie puts the radio into sleep mode while it's programming. This means, after the Genie gives a green LED light, if it's pulled out immediately, the radio screen will stay black.  After turning on the vehicle's engine, letting it run 1 minute, ...
    • Genie won't program for an older vehicle

      After turning on your Chrysler-based vehicle, letting it sit for 1 minute, then installing your OBD Genie into the OBD II port of your vehicle, if you don't get a solid green light indicating programming, have done a CANBUS reset, and still don't get ...
    • OBD Genie Troubleshooting Guide

      OBD Genie Troubleshooting Guide Following this simple instructions is the first steps to getting you back on the road with all the new modifications.      My OBDGENIE keeps flashing red lights. Turn the vehicle off. Unplug the OBDGENIE and wait 10 ...
    • Q: I installed the C-ACC-LD OBD Genie programmer in my 2011-2014 Chrysler 300 / Dodge Charger to enable AUTO temperature control and it's not working.

      Q: I installed the C-ACC-LD OBD Genie programmer in my 2011-2014  Chrysler 300 / Dodge Charger to enable AUTO temperature control and it's not working. A: If the programmer's embedded LED turned green then the vehicle's computer has been programmed. ...