Lockpick - Blue / Black Screen

Lockpick - Blue / Black Screen

How do you have the camera connected to the rear camera interface?

The camera yellow video plug will plug into the yellow RCA plug on the big 52 pin harness labeled camera input. Check the ARC box, pop off the top and make sure the dip switches in there are set for:

001110

1 is up

0 is down

Next you will want to check power and ground from the camera.   


At this time we no longer cover support of this product. This information may be dated.

If you have any additional questions or concerns, please contact the makers of the lockpick by clicking here.


 


    • Related Articles

    • IOB Genie gave green light but screen is black

      This Genie puts the radio into sleep mode while it's programming. This means, after the Genie gives a green LED light, if it's pulled out immediately, the radio screen will stay black.  After turning on the vehicle's engine, letting it run 1 minute, ...

    • IOU has blue screen and Cadillac splash after install

      This is completely normal, as the screen will be blue, count down then give a Cadillac splash screen upon install install. This will not correct itself until the vehicle is restarted.

    • Cargo Camera - Blue / Black Screen

      If you are experiencing problems with your cargo camera and if you are getting a blue screen please make sure to follow the steps below.   PROPER CONNECTIONS.  1. Make sure that you have the proper connections.       *If you have a factory rear ...

    • Denzo shows splash screen, then blue screen with clock

      When turning on the vehicle, if your Denzo headunit give you the GMC splash screen, then gives you a blue screen with just the clock on it, no allowing you to navigate further, try the below steps in order. Moving to the next step, if the last didn't ...

    • IOU Navigation Black Screen

      If you get a black screen with only the vehicle marker (arrow) when you click on navigation, you will need to: Either turn off the vehicle and let it sleep for a few minutes. Or remove and reinsert the map card.