Toyota Tacoma Entune 3.0 won't set clock or tracking miles/kilometers
If your new Entune 3.0 radio doesn't allow you to press on the time and set the clock or miles or kilometers don't track or allow change, that's related to the GPS connection. Make sure your GPS antenna is fully connected, that the antenna is placed in a position to retrieve good signal and the antenna is in working order. This will resolve the issue. If not, then the radio itself may have an issue.
Related Articles
Time won't set for non-Nav Sync 3
Despite not having navigation programmed to the APIM module, for the non-Nav version of Sync 3 upgrades, all APIMs use a GPS antenna to set time. If time will not stay, when set, check your GPS antenna and make sure it's plugged into the ...
2016-2020 Toyota Tacoma Entune 3.0 radio won't power on after installation
After installation of your Entune radio, you may run into a situation where your radio won't power on. The reason being where one of the harnesses is hooked up; You have to move it from the right to left left, behind the unit.
2016 - 2020 Toyota Tacoma Entune 3.0 Radio doesn't get any audio
After installing this upgrade, and allowing the vehicle to sleep up to 48 hours, if there's no audio then check to see if there's a JBL logo on the vehicle's radio fascia. If so, that means there's an amp incompaitbility and this upgrade will not ...
Toyota radio resets
On Denso-ten unit: Hold Apps or Info then flip headlights switch on/off 4 times, this will take you to diagnostics menu. Hold INIT and MEMORY CLR to delete data, if you went through INFO it will be in the the first option. Panasonic Unit: Hold Menu ...
Denzo shows splash screen, then blue screen with clock
When turning on the vehicle, if your Denzo headunit give you the GMC splash screen, then gives you a blue screen with just the clock on it, no allowing you to navigate further, try the below steps in order. Moving to the next step, if the last didn't ...