UAV/UAX windshield wipers won't stop after installing unit/Genie

UAV/UAX windshield wipers won't stop after installing unit/Genie

Please have your vehicle completely turned off, or battery terminals removed, during the installation process of your retrofit upgrade.
 If you install this with your vehicle on or in accessory and try to use the Genie, even if it gives you a green confirmation light, you will likely blow a fuse or relay in your vehicle. The common symptom this causes is your windshield wipers going off constantly. You may also experience bezel control issues as well.

If unable to isolate the affected relay or fuse, please to to a local dealer to have the vehicle looked at.

    • Related Articles

    • UAV & UAX bluetooth range is too short

      After installing a UAV or UAX upgrade, and pairing the head unit with a bluetooth device,  if you notice your linked bluetooth device needs to be extremely close to the unit to hold signal, you'll need a small blue fakra, with an adapter amplifier, ...

    • UAX / UAV doesn't give display

      After installing your UAX or UAV upgrade, if you notice that you have a black screen. This is caused by one of two issues: The Genie didn't produce a green LED to properly program the vehicle to turn on the radios screen. To fix this: If you have a ...

    • OBD Genie not programming an older vehicle

      After turning on your Chrysler-based vehicle, letting it sit for 1 minute, then installing your OBD Genie into the OBD II port of your vehicle, if you don't get a solid green light indicating programming, have done a CANBUS reset, and still don't get ...

    • UAV to UAX Retaining Sirius Guardian / UConnect Access

      When upgrading from a UAV to UAX, you will retain Sirius Guardian / UConnect Access, due to already having the neccassary 4G antenna. You will need to reach out to Sirius Guardian to have the account transferred over to the newly installed UAX, ...

    • 2019 Heavy Duty UAV or UAX Upgrade Climate issue

      Since last year we've had an issue where a 2019+ Ram truck customer (who has installed either a UAV or UAX upgrade) increases or decreases their cabin temperature around 70-74 degrees the vehicle either goes full heat or full cold. This happens ...