Camera Picture Has Wavy Lines, Rolling View, or Fuzzy Picture
The MyGIG FIM lockpick will need to be grounded to counter noise interference the cam is receiving.
Please locate the green wire with white stripe on the harness end that plugs into the lockpick module.
You will need to run a wire from the green wire with a white stripe there over to the Chassis ground wire located on the lockpick harness.
At this time we no longer cover support of this product.
If you have any additional questions or concerns, please contact the makers of the lockpick by clicking here.
Related Articles
Cargo Camera - Grid Lines
To turn off Grid Lines for a RAM Cargo Camera: You will need to snip the green wire, this might be labeled "Parking Lines". If you are still seeing the grid lines (parking lines) after snipping the green wire or if the green wire is already snipped, ...
GM - Cameras - Turn On Grid Lines
Turning Grid Lines On: If you are or aren't seeing grid lines on the screen as you are using the rear view camera, simply follow the instructions down below. Also, click on the link below to see an example of how to turn the grid lines on or off. ...
IOU Upgrade Backup Camera TSB
On some model Silverado trucks the backup camera mounting location needs to be modified to accept the new camera included in the upgrade. If attempting to install the new camera into the tailgate handle, and you run into an issue where the camera ...
Cargo Camera Icon
"My cargo camera icon is not showing up, but I got a green light when I used the OBDGenie?" Perform a can-bus reset. CAN-bus Reset: Remove positive and negative cables from the vehicle battery. Touch and hold the cables together for 5 - 10 seconds. ...
"Service Rearview camera" error after installing GM back up camera
Once confirming you're pre-wired in a 15 model vehicle or installing the camera in a 16 year vehicle or newer, you'll typically want to install the camera wiring into the dummy plug. However, those who have a locking tailgate handle be sure to swap ...