HVAC plug missing from main harness (4" to 8" upgrade only)
The design of the harness was changed recently. The red plug that would've been installed in the bezel behind the HVAC panel is no longer required. Please proceed with the rest of the installation.
Related Articles
BATTERY/BCM DRAINAGE EXPEDITION 4 to 8 Sync 3 Upgrade Kit
Are you experiencing battery drainage or your BCM does not sleep after the vehicle is turned off? Make sure that you are running the power to an ignition source as seen on the installation video. The same plug that will run to an ignition source is ...
Ford Mustang 4" to 8" Sync 3 Upgrade: "I'M MISSING CABLES FROM MY KIT"
If you've purchased the Ford Mustang 4" to 8" Sync 3 upgrade and watched our installation video you may see that there are two small cables that are mentioned and is missing from your kit. We are sorry for the confusion, but we've improved our kit to ...
2013-2018 Dodge Ram Factory 8.4" Bezel 4 speed HVAC Conversion
Below is information for the 4 Speed HVAC Conversion. If you currently have a 7sp fan prior to the upgrade, click here. Please click here for the product page. Common Problems and Troubleshooting Steps (4 speed to 7 speed) - No power to the 8.4 ...
I'm Missing An Antenna Plug When Installing
Not all vehicles are equipped with every plug. You will probably only need 3-4 of these plugs at most. Please see attached picture for a description of the plugs.
Convenience & Comfort settings missing after IO6 upgrade
If these settings are missing, you simply have to allow the vehicle to sleep for up to 48 accumulative hours. If these doesn't work, do the following: Try each of these steps in order. If one fixes your issue, you don't have to move to the next step. ...