Jeep Spare Tire Camera Reverse Image

Jeep Spare Tire Camera Reverse Image

If you have a camera where the left side of the screen is showing the right side of the vehicle the camera is most likely configured for front facing camera.


To reverse the image to rear view, and also have your grid lines appear you will need to cut the white, and green wires that are located near the first black connection on the camera. If you start from the camera, and follow it down the wire you should see these wires shortly before you reach that first black connection. 


**********************************************************************************************************************************************************************


Grid line options: Default setting is to display grid lines. To remove the grid line display, connect the two green wires near the end of the camera harness. 


Display options: (Not to be used in this application!) Default setting is mirror image display for rearward facing camera (rear view) installation. To change to non mirror image for forward facing camera (front view) connect the two white wires near the end of the camera harness.




 This also depends on the way the camera was manufactured. Some of the newer models do not feature those loops. In this case, the customer can reach out to Brand Motion for further assistance. We have worked with them before in this case, and they asked us to direct any such cases over to them.


    • Related Articles

    • Can't navigate multiple camera inputs with UAQ/UAS upgrade

      If your vehicle has multiple cameras, such as a reverse, cargo and front camera, and you have the appropriate hardware to route which camera image appears in your radio head-unit's screen, note that not all of these functions will be retained when ...

    • No Image/"Service Rear Vision Camera" Error (Auto-Locking Tailgate Only)

      If you have factory auto-locking tailgate, the port in the install video is not compatible. You will need to replace the existing cable running from the tailgate handle (fatter wire). Please see attached picture for correct plug. It is tucked up to ...

    • NO CAMERA IMAGE ON THE SCREEN

      There are only 3 things that can affect the camera not working.   1. POWER & GROUND- Power and ground as mentioned earlier is recommended to be plugged into a 12-volt accessory outlet for example the cigarette port. Please check the connection on ...

    • IOU Upgrade Backup Camera TSB

      On some model Silverado trucks the backup camera mounting location needs to be modified to accept the new camera included in the upgrade. If attempting to install the new camera into the tailgate handle, and you run into an issue where the camera ...

    • Cargo Camera Icon

      "My cargo camera icon is not showing up, but I got a green light when I used the OBDGenie?" Perform a can-bus reset. CAN-bus Reset: Remove positive and negative cables from the vehicle battery. Touch and hold the cables together for  5 - 10 seconds. ...