How to Operate IRD306DP

IRD306DP is a Digital Vibration Meter that allows for measurement of General Machinery Vibration. It works with the Velometer IRD531. The following steps list the method of operating an IRD306DP.

1. Step 1: Insert two numbers of 9 V Batteries (chargeable or rechargeable - any will do) in the battery compartment. Ensure a Snug Fit with the Battery Snappers
   
2. Step 2: Connect the supplied cable to the instrument and its other end to IRD531. Ensure not to damage the connector or pins in the process (do not apply excess force. Use the guide vanes for a smooth and proper connection)
   
3. Step 3: Connect the Magnet or Stinger to the Sensor IRD531 and ensure that the accessory is completely tight (a loose magnet or stinger will interfere with measurements)
   
4. Step 4: Turn on the Meter using its power switch and select the mode (Velocity or Displacement) in which you wish to measure the vibration
   
5. Step 5: Place the sensor on the equipment on which the vibration is to be measured. Allow the readings to settle for 2 seconds. Observe the readings and note it down for future reference.
   

IRD306DP reads Vibration Velocity in mm/sec RMS and Vibration Displacement in microns peak-peak

• Related Articles

• About IRD306DI

  IRD306DI is a Portable Digital Vibration Meter. It is meant for Vibration Measurement of Large Machinery. It is manufactured by IRD Mechanalysis Limited in Maharashtra in India. It boasts the following features: It works with Sensor IRD544 which is ...

• What is Spike Energy and why is it useful for Bearing Health Monitoring?

  Introduction to Spike Energy IRD Mechanalysis have developed “Spike Energy” to detect rolling element bearing condition in its very early stage. “Spike Energy” detects low amplitude transient impacts generated within the ultrasonic frequency range by ...

• How to Check Calibration of IRD306DI with its Sensor

  In order to check the Calibration of IRD306DI with its Sensor IRD544, a Portable Vibration Calibrator or a Permanent Vibration Calibrator is needed. The Calibrator should have the facility to generate a pure vibration of a fixed frequency and a fixed ...

• How to correctly read Vibration on IRD811

  IRD811 is an Analog Display Vibration Meter. It has two scales for two range multiples. If you are reading in the multiple of 10, then you need to refer to the top 0 to 1.0 scale and grade it according to your full scale range selection. If you are ...

• What items are offerred as Standard Accessories in a Kit of IRD306DP Digital Vibration Meter?

  When you purchase a IRD306DP Digital Vibration Meter Kit - you receive the following: IRD306DP Vibration Meter - 1 No. IRD531 Vibration Sensor - 1 No. Coiled Cable with TNC Connector - 2 Nos. Stinger - 1 No. Magnetic Base - 1 No. Carry Bag - 1 No. ...