How to calibrate the camera

How to calibrate the camera


We recommend this article for IT members of schools or districts.
You don't need to calibrate the camera every time you're using your Lü. 

Calibration should be performed when the detection of the ball on the wall is inaccurate or when there are false detections.

It's mostly when the camera itself is hit by a ball that you will need to proceed with a new calibration. Even if the camera move just a tiny bit, it can have a impact on the detection.

Follow these steps to calibrate:

Select the gear icon in the left panel.

        










Click on the button "Start" in the Calibration section.















Choose the calibration method that suits you best: Automatic or Manual. For the manual calibration, follow the instructions displayed on the screen.

        

















When you calibrate the camera, you have to adjust the green rectangle to make it fit the projection screen. The green rectangle represents the detection zone. Adjust the screen as if you were looking through the camera.

If the calibration fails, try the other method.


After the calibration is complete, select Test mode. Throw a few balls at different places in the projection to test the detection accuracy.











Press “Esc”, then “OK” to return to the home page.

For more details on calibration, check out the “Learn to calibrate the camera” tutorial in the Help Center of the Lü system.







       









  




    • Related Articles

    • Camera not detected

      We recommend this article for IT members of schools or districts. If a message indicates that the camera is not detected or if the calibration screen is a blank white screen, we recommend that you follow these steps one by one to resolve the problem: ...
    • Wrong resolution

      We recommend this article for IT members of schools or districts. 1. If the wrong Resolution message appears, go to the Lü settings by selecting the gear icon located in the left side panel. 2. Then select the System Status tab, and then click on the ...
    • Lü 1st generation - Change the image ratio

      If any part of the screen does not display correctly in the projection, the aspect ratio may have been accidentally changed. To change the image ratio and thus have a full screen, press the Aspect button using the projector remote control and choose ...
    • Möbil - How to setup your unit

      We recommend this article for IT members of schools or districts. To learn how to set up the Möbil unit, please watch this video : https://www.youtube.com/watch?v=liMPZrsbCOI You can also check the User Guide attached to this article.
    • Best Practices

      We recommend this article for IT members of schools or districts. 1. To start using your Lü, you must turn on the projector and the remote-keyboard first. Then, wake up your Lü by pressing any key on the keyboard and you'll be able to start using it. ...