Paper Out Error is displayed in PrintHub (LX610).

Normally, the paper out error indicates that you are at the end of a roll of label stock.  You will need to load another roll of media in the printer.

If the media is loaded, and the error appears when you send at print, or the error appears at printer startup with no media loaded,  it means that the cable connecting the smart chip sensor has not been properly installed. Review the setup video.  This connection is shown at the 1:10 location.  Make sure this wire is securely connected.

If the wire is connected and you have already loaded new media in the printer, but the error still occurs when you start printing, try one of these solutions:

1. In PrintHub, go to Printer Settings - Advanced - Press the Calibrate Paper Sensor button.  It will prompt you to remove the paper from the printer. Press the unload button to do so.  
   
2. Blow out the sensor area with canned air.  Remove the paper from the printer and place the nozzle of the air can in the paper infeed location.
   
3. Finally, move the gap sensor position slider back and forth to possibly dislodge any obstructions. 
   
4. This can also be caused by an unreadable smart chip in your digital die-cut media in some rare cases.  However, there are usually other symptoms present, which is explained in this article.

Article ID: 060520B

• Related Articles

• “TOF Error” is displayed in the status monitor. Label stock will not load automatically or printer does not detect the label stock. (LX2000).

  The LX2000 is not properly sensing the gaps between the labels on your label roll. (TOF = Top of Form) Check the following settings:  Try pressing the "Resume/Feed" button on the front of the printer. If the error continues, press the “Cancel” button ...

• Unable to feed paper / media / stock on initial load. Printer will not grab the paper (LX610).

  Issue.  Wear strip is too thick, too wide or improperly installed which causes it to protrude too high into the paper path.  This will prevent the label stock from feeding into the printer.  It gets stuck right before the wear strip. If the wear ...

• The smart Chip in my Primera LX610 media is defective. When inserted the media is not recognized as Digital Die-cut Media. The media feeds forward and back 12". When the print is sent, Gap Sensing Error is displayed or Non Digital Die-Cut Error message is displayed

  When you insert digital die-cut media you should see an icon in the upper left corner of print-hub indicating you have Digital Die-Cut Media and a corresponding percentage remaining. If you do not see the icon make sure your media is digital die-cut ...

• LX 2000/ LX 1000 - Error Message: failed printhead, printfailure impropershutdown

  LX2000 - Error Message: failed printhead, print failure improper shutdown Solution 1: Perform a print head alignment described below.   This will clear and resolve the mentioned error message and allow you to print.  Solution 2: Install a new print ...

• Filter Failed message appears in print queue. Eddie or LX Series Printer is not printing. Ventura, Catalina, Big Sur, Monterey and Sonoma require new drivers (Mac).

  Try these steps in order. 1. Install the latest version. Occasionally, the driver will be corrupted after an OS update. Download the latest version from the products download page. You can find the latest software for your product at the location ...