Display Operation - Single Group

Display Operation - Single Group

Slayer Single Group Display Operation




Objective: 
Navigate touch operations of LCD display.

Parts:
  1. 99004-60120 DISPLAY ASSEMBLY, HOME


Tools:
  1. Pad of your thumb.
The operation of the single group display is best described in the video below. Using as much surface area as possible on your finger and being intentional about your touch. 


Known Issue:
The down arrow on Slayer Single Group's featuring a LCD display (machines manufactured and as a spare part after January 2020) indexes towards the bottom of the arrow. Access to the contact point is easier when you press down on the cup tray slightly. 

Slayer Single Group's manufactured before January 2020 feature an OLED display. All displays purchased as a spare part through Slayer's Customer Service department are the new, LCD, version and require factory configuration to remain compatible with older serial numbers. Please provide your serial number and date of manufacture (stamped on the data plate) to ensure the correct display configuration before purchase.


Questions or concerns? Please contact support@slayerespresso.com

    • Related Articles

    • Panel Installation - Single Group

      Single Group Panel Installation Slayer recommends that all service be performed by an experienced Slayer Espresso trained technician. Objective: Install and remove panels for maintenance, service, and panel replacement. Please contact Slayer Tech ...

    • Operation and Understanding of Single Group Display

      Using the full pad of your thumb and slow and very deliberate on touching or scrolling the screen. See the pictures of where the sensors are and the picture of the screen without the glass. Pausing a beat when touching or scrolling is advised. You ...

    • Single Group Electronics Identification Diagram

      2020 Single Group 1. Display Ribbon Cable 7. Group Cap Magnet Switches 2. Relay Harness 8. Steam Tank Level Probe 3. 24v DC Power 9. Transducer 4. Pump 10. SSR Steam Relay 1 5. Solenoids 11. SSR Steam Relay 2 6. Brew Tank RTD 12. SSR Brew Relay If ...

    • Replacing Circuit Board Single Group

      Replacing Circuit Board Single Group   Tools Needed: #2 phillips head screw driver, #0 phillips head screw driver. Time Needed: 10 minutes Unplug machine and turn off water Remove Cup Tray Remove the two screws on the back panel under where the cup ...

    • Testing No Power, Single Group

      Testing No Power, Single Group Time Needed: 10 Minutes Parts Needed: None Tools Needed: #2 Phillips Screwdriver Multi Meter Circuit Board Reference #1 - Main power - 24v DC from power supply #2 - Relay #3 - Display ribbon cable #4 - Transducer #5 - ...