Setting up Fabrication Software to round measurements from a laser measuring device
Summary
Solatech Window Covering Software 4.2 (Fabrication), must be setup in a specific way in order for measurements from a laser measuring device to be rounded properly. This article provides instruction on proper setup.
Instructions
- From within Solatech, go to File>Preferences
- In the left hand column, under Hardware, select Leica Disto
- In the right hand column, select the Settings button
- On the General tab, place a checkmark to the left of Round Measurements down
- Do not place a check mark to the left of only for electronic measurements
- Click OK to exit and save
Applies to
- Solatech Fabrication software (v. 4)
Related Articles
Inaccurate Measurements When Using Laser Measuring Devices
Summary Laser Measuring Devices depend on the reflection of an internally generated laser beam to measure the distance between two points. In a very few instances, the distant surface will "absorb" or "refract" rather than reflect the laser beam, ...
Setting up a Disto D330i or D3aBT Laser to transmit customer measurements in SalesPRO
Summary This articles explains how to use Leica Disto Transfer software to transfer customer measurements into SalesPRO. Please note these instructions are only for the Leica Disto Models D8, A6, D330i and D3aBT. Installation of Disto Transfer ...
How to setup a Leica Disto X3 laser to transmit measurements
Summary This article describes how to setup a Disto X3 laser to transmit measurements, either into SalesPRO software or into another type of program (Notepad, Excel, Word, etc.) Instructions Turn on your X3 laser (Bluetooth is auto enabled) . Select ...
Apparent Rounding Errors when using Leica Disto™ Bluetooth® Laser (Applies to Version 4.2 ONLY)
Summary The Leica Disto™ Distancemeters with Bluetooth® allow you to set the display resolution to different values, for example to indicate 1/8 inch increments, rather than the native 1/32 inch increments. While this allows a greater ease in quickly ...
How to set up a Leica Bluetooth Laser to work in Solatech (Version 4.2 ONLY)
Version Important This article applies only to Solatech Window Coverings Software release 4.2. Summary This article explains how to pair your Leica Bluetooth Laser with your computer and set it up to work with your Solatech software. Steps This is a ...