Dorsum + Imprint scanning

Dorsum + Imprint scanning

Marking landmarks on the foam-box
Here is a suggestion to identify 3 corners of the foam-box. Only 3 because when merging the 2 parts, if you mark 4 corners, the software might invert the top with bottom of foam-box. By making physical markers on the foam, you will make sure that when you put landmarks in MSoft or if you use the function ‘Align with points’, you will put the points at the exact place on both parts, to ensure a good alignment.

 

You can take a pen, as done on the picture, a washer or a coin but make sure you press them at the same depth each time because when you put the points on the screen, they must be at the same height



Learn how to scan a dorsum+imprint in this tutorial video :

    • Related Articles

    • Starting points for Dorsum + Imprint scans

      In order to help you with your scanning experience, we have created the image starting point. This tool helps you get a good scanning position at first, hence will render a perfect scan. Please follow the instructions below for the different body ...
    • Starting points for dorsum scans

      In order to help you with your scanning experience, we have created the image starting point. This tool helps you get a good scanning position at first, hence will render a perfect scan. Please follow the instructions below for the different body ...
    • Face scanning

      To help you with your scanning experience, we have created a tutorial video to show you how to scan a face:
    • Head scanning

      Note that the clusters of targets put on the head will be used as a starting point (or reference point if tracking is lost) during the scanning process. To begin with scanning, follow these steps: Once ready, start the scanning session by pressing ...
    • Elbow (arm) scanning

      To help you with your scanning experience, we have created a tutorial video to show you how to scan an elbow: