What needs to be configured on my computer when it is connected to the LAN port on the Gizmo?

What needs to be configured on my computer when it is connected to the LAN port on the Gizmo?

You simply need to configure your computer to obtain an IP address automatically and then connect it to the LAN port on the TeleBlend Gizmo using a straight Ethernet cable.
    • Related Articles

    • Which is the port on the Gizmo that needs to plug into the modem?

      The WAN or Internet port on the TeleBlend device needs to be connected to the Ethernet port on your cable modem or router using a straight Ethernet cable.
    • Setting up your TeleBlend Gizmo in a DMZ

      You can setup your TeleBlend Gizmo in the DMZ (demilitarized zone) of your router if you continue to have problems where you lose dial tone and have to restart the TeleBlend unit to restore it or where you have one-way or two-way audio problems on ...
    • Which phone port on the Gizmo is active?

      The only phone port that is used by the TeleBlend service is the Phone 1 port. Plug your analog telephone into the Phone 1 port of the device.
    • Can I use my computer and talk at the same time

      Yes, the TeleBlend service functions using a stand-alone unit, Gizmo/ATA and therefore the operation of your computer does not affect the phone service. If you are using bit-torrent applications that consume a large amount of bandwidth, the overall ...
    • What is the IP address range served on the LAN side of the Gizmo?

      The IP address range used by the TeleBlend devices are as follows: Innomedia: 192.168.251.2 through 192.168.251.254 Telco Systems AC-211: 192.168.251.2 through 192.168.251.254 Linksys SPA 2102: 192.168.0.2 through 192.168.0.254