Cinergy appliance not appearing on network

Network cable was plugged into the incorrect ETH jack. It plugs into the jack next to the headphone jack. Unit must be power cycled when changing ETH ports.

• Related Articles

• Touch Panel Controller (TCP) appears dead. Projector is on but cannot be controlled via TPC or net

  Christie xenon cinema projectors have three separate power supplies; the lamp power supply (LPS), the low voltage power supply (LVPS) and the standby supply.  The standby supply provides power to the touch panel controller (TPC) and the network ...

• Exhibitor Self-Installation Instructions-2Bay-QNAP

  Self-Installation Instructions Unbox server and inspect for any damage during shipping. On the back of the server are three network ports (see below image for reference). The top left port connects to your ‘media’ network. This will be the network ...

• Projection Equipment IP Addressing Schema

  While there is no true digital cinema IP addressing standard, there is a very popular one that was used by many theatres, including those on the Strong and Christie NOC's (Network Operation Centers), as well as some that were installed as ...

• Controlling a Denon Professional BluRay deck from a GDC server

  The Denon Professional BluRay deck can be controlled by the GDC SX and SR series server by using creating a network socket device.  The player needs to be set up with a static IP address on the same subnet. 1.      In the automation tab set up a ...

• Doremi Maintenance Program Notification Pop Up

  Skip to Main Content Doremi Maintenance Program Notification Pop Up Feb 18, 2021•Knowledge Question This article applies to DCP2000, DCP-2K4, ShowVault, IMS1000, IMS2000 and IMS3000. What is the Maintenance Program notification pop-up regarding? ...